The Statomix™ FM Series mixers were developed for 2-component coatings and other very low viscosity materials. The mixer housing is flexible and made from high-strength Polyamide with low moisture absorption and is suited for a flexible installation. The Statomix™ FM Series mixers are not suited for high pressure or for mixing of high viscosity materials. The mixer should be cleaned immediately after use with a mixture of solvent/air.
| Material | Housing: Polyamide (PA 12 free from plasticizer) Elements: Polypropylene (PP) |
| Number of Elements | 25 or 36 |
| Retention of elements | By means of a cripm on both ends of housing |
| End Connectors | Plain ends |
| Max. Operating Temperature |
According to the table below. For high pressures and temperatures above 40ºC it is necessary to use a protective covering |
| Tolerances | Length +/- 1mm |
|
Part Numbers |
Inside |
Number of Elements |
Outside |
Length L (mm) |
Notch Recess |
Max. Pressure (bar) |
|
FM 06-09-24 |
6.4 |
24 |
9 |
188 |
13 |
14 |
|
FM 06-09-36 |
6.4 |
36 |
9 |
263 |
13 |
14 |
